Great Dane GSRKA1934S User Manual Page 29

  • Download
  • Add to my manuals
  • Print
  • Page
    / 64
  • Table of contents
  • TROUBLESHOOTING
  • BOOKMARKS
  • Rated. / 5. Based on customer reviews
Page view 28
SERVICE STEERING AND BRAKES
SERVICE STEERING AND BRAKES- 27
Checking Transmission Tracking:
Check and adjust motion control linkages. See Check-
ing and Adjusting Motion Control Linkages in the SER-
VICE TRANSMISSION section.
Start engine and run until it reaches normal operating
temperature.
Move machine to an open, level area for operation.
A
B
C
D
Drive machine forward, pushing both control levers (A)
all the way to speed control bar (B).
If machine does not drive in a straight line, an adjust-
ment is required.
Adjusting Transmission Tracking:
Adjust appropriate control rod swivel (C) located on
each side of machine.
If machine tracks to the right, remove spring pin (D)
and rotate left control rod swivel one turn clockwise.
Install spring pin (D).
If machine tracks to the left, remove spring pin (D) and
rotate right control rod swivel one turn clockwise. Install
spring pin (D).
Check transmission tracking again and adjust as re-
quired until machine drives in a straight line.
Adjusting Forward and Reverse Speeds
Adjusting Forward Speed:
Park machine safely. (See Parking Safely in the
SAFETY section.)
1.
2.
3.
4.
5.
1.
2.
1.
B
A
C
Picture Note: Arrow shows direction of speed control
bar (A) movement when decreasing forward speed.
Loosen lock lever (B) on speed control bar (A).
To decrease forward speed, pull speed control bar (A)
toward the operator’s station.
To increase forward speed, push speed control bar (A)
forward (away from operator’s station).
3. Tighten lock lever (B).
Adjusting Reverse Speed:
Park machine safely. (See Parking Safely in the
SAFETY section.)
Loosen jam nut (C) on cap screw (D) on each side of
machine.
To decrease reverse speed, turn cap screw (D) coun-
terclockwise.
To increase reverse speed, turn cap screw (D) clock-
wise.
Tighten jam nut (C) on cap screw (D) on each side of
machine.
Adjust Neutral Switch
2.
1.
2.
3.
Page view 28
1 2 ... 24 25 26 27 28 29 30 31 32 33 34 ... 63 64

Comments to this Manuals

No comments